JACK LALANNE'S POWER JUICER
ASSEMBLY
POWER JUICER
ASSEMBLE AS SHOWN |
STEP 1
Place base on a dry flat
surface with locking bar in
down position as shown.
In front of the machine
(spout side).
|
|
STEP 2
Place receptacle on the base,
with juicer spout facing direction
of locking bar. Settle receptacle
into alignment. |
|
STEP 3
Place filter inside receptacle,
matching the opening on its
bottom to the screw peg
connected to the base. |
|
STEP 4
Place blade inside filter,
centered over screw peg.
Using orange crescent tool,
place its pegs into the holes
in the blade and turn clockwise
until tightened.
IMPORTANT: Do not over
tighten as the screw peg will.
Remove crescent tool and
set aside.
CAUTION: Do not leave
tool inside juicer
|
|
|
STEP 5
Place lid with built-in pulp guard
attachedon top of receptacle,
making certain it is snugly
aligned with the pulp guard
facing in the opposite direction
of the juice spout. Lock lid into
place by lifting locking bar up
until it clicks into grooves
located on both sides of the lid.
Make sure locking bar is in the
full upright, locked position.
IMPORTANT: The unit will
not start until this bar is properly
locked in place. |
|
|
STEP 6
Insert pusher into chute. Always
use pusher to feed fruits and
vegetables into unit. Push gently
never force. The blade will do
the work. |
|
|
|
